Keypad Functionality - Chacon 34048 User Manual

0. Introduction
Thank you for using this product.
• Please read all instructions carefully before using the product.
• Do not attempt to disassemble or repair the product yourself, as this will invalidate the warranty.
• This product is compatible with these references: 34035, 34036, 34038, 34043, 34044, 34045,
34046)
1.1. Battery installation: Central alarm unit with motion detector
2. Using a crosshead screwdriver, remove the screw from the back of the
opening detector.
3. Slide the cover down to access the battery compartment.
4. Insert the batteries, ensuring correct polarity (+/-).
5. Close the compartment with the cover and screw.
Note: When the battery is low, the LED indicator will flash slowly (3s/flash)
2. Installing the alarm unit
Once the batteries have been installed, choose t
he location where you wish to place your opening detector.
There are two methods:
a) Fix the bracket to the wall using the dowels and screws
provided and then fit the detector onto the bracket, ensuring the best possible range.
Recommended installation height: Maximum 160cm and minimum 30cm.
NOTE: Adjust the installation angle so that it faces downwards.
b) Simply place it on a table or desk for easy access to the keypad.
3. Setting up the personal code
Once you have placed your batteries, you have 15 seconds to choose a four-digit code. If you have
not had time to enter your personal code, the code 1234 will be saved by default.
Note: Each time you install batteries, you will need to set up your 4-digit code again.

4. Keypad functionality

a) Home Mode: Enter your 4-digit code, then press the «1» button. You will hear a «beep» to
indicate that the alarm will enter «home» mode after 30 seconds.
100°
100°
2m
80° 60° 20°
4m 6m 8 m
EN