Cleaning The Water Tank - ARIETE 1381 Manual

Cleaning the steam/hot water wand
Warning!
The procedure shall be carried out when the steam/hot water wand has cooled down in order to avoid
burns.
After each use, clean the steam/hot water wand using a damp cloth to remove any external milk residues. To
remove any internal residues, follow the steps below:
for a few seconds.
Clean the components of the steam/hot water wand regularly.
downwards. Wash under running water. The hole can be cleaned using a non-abrasive cloth.
- Install the steel tube (K) until it is locked in place. Insert the rubber part by pushing it upwards. If needed,

Cleaning the water tank

Regularly clean the inside of the water tank using a sponge or a damp cloth.
Cleaning the appliance body
Warning!
Do not use abrasive detergents.
Cleaning the removable grid and the drip tray
Warning!
This cleaning operation shall be carried out when the appliance is turned off and the plug disconnected
from the power outlet.
Occasionally empty the drip tray (F).
of water and shall be emptied.
DESCALING
Warning!
Do not use vinegar or other descaling agents not authorised by the Manufacturer.
Warning!
Danger of burns due to splashes of hot water and steam that may escape from the steam/hot water
wand.
operation be compromised after some time, due to frequent use of hard and very calcareous water, descaling
can be carried out in order to remove the malfunction. For this purpose, only use a citric acid-based descaling
) to stop delivering steam.
31