Alpine HALO9 Quick Reference Manual page 17

• If the GPS Antenna is mounted near the unit, the
reception becomes poor, and the location of your vehicle
may not be displayed correctly.
– Mount the GPS Antenna far away enough from the unit.
– Bundle the GPS Antenna cable away from the rear of the unit.
• Some thermal reflection type or thermal absorption type
glass may interrupt high frequency waves. If reception is
poor with the antenna installed inside the car, try to
mount the antenna outside the car.
cted.
oice can
Note on using HDMI Connection Cables
ould not
When using HDMI connection cables, secure the
y cause a
cables to the HDMI Terminals with the supplied HDMI
afely
Fixation Bracket.
on and
1
nfirm
at the
rophone
e the
Adjusting the display position
(iLX-F509/iLX-F511)
Depending on the vehicle, the front-back display
position differs. To adjust the front-back position, set
the slider to the forward position.
plate.
Default setting: Back position
Front-back position
re
board or
ed) by any
Secure the HDMI Fixation Bracket with the
screw (A).
HDMI Terminal
HDMI Fixation Bracket
(Included) (A)
<Forward position> <Back position>
51.5 mm
1
Remove 4 hexagon bolts from both sides of
the unit.
2
Pull out the slider to the forward position.
(To return the slider to the back position,
push it in.)
3
Install 4 hexagon bolts to secure the slider.
Installing the Unit (iLX-507)
1
Mount the original mounting bracket to
the unit using the supplied screws.
If you do not have the original mounting bracket,
mount the Double din KIT* (provided with the side
mounting bracket), etc. to the main unit.
31.5 mm
* Sold separately.
Screws (M5 × 8)
(included)
ALPINE iLX-F509 68-41657Z87-A_QRG (EN)
Hexagon bolts ×4
Slider
Original Mounting
Bracket
Face plate (Included)
EN
FR
ES
15
-EN