Bluetooth ® Ios Procedure - Montarbo Five-O REBEL Owner's Manual

BLuEtootH
®
iPhone – iPad procedure
® ®
[1] From the Settings menu > activate bluetooth
[2] Set the potentiometers and MP3 Master Volume in central position. It's necessary to listen the tones issued by MP3/BLUETOOTH section.
[3] Switch on the REBEL unit by pressing the DC switch to "I" (if the unit is connected to 220/240V AC, please press even the AC switch to "I").
[4] Pressing the MODE button (by default the MP3 player is turned on) the REBEL display shows the message "Bluetooth Initializing ...".
A tone (bup) is issued, and the detection procedure starts.
[5]When the external device is identified, the REBEL emits a sequence of two tones (bup - bup) and your iPhone
shows BLUETOOTH (in upper case). It means that the Apple
explained in step [11].
[6] If the REBEL display shows "Unconnected", please repeat steps [4] and [5].
[7] If after 3 attempts the REBEL display still shows "Unconnected" turn off the REBEL placing the DC switch to "0".
[8] Before turning on again the REBEL, delete or ignore other bluetooth devices already present on the Apple
Menu "Devices" > blue arrow
[9] Wait for 5 seconds, then power on again your REBEL pressing the DC switch to "I" position.
[10] Repeat the steps [4] and [5].
[11] To connect both devices press "not connected" from the external device. Once connected, the REBEL emits a tone (beep) and display
shows the message "Connected".
[12] Now you can send any signal to REBEL through the Bluetooth
Apple®, iPad® and iPhone® are trademarks of Apple Inc., registered in the U.S. and other countries.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Elettronica Montarbo srl is under license.
REBEL
Owner's manual |
12
ios pRocEDuRE
® on your Apple
click "Forget this Device".
® device > 'I' > Devices > Looking for ...
device is synced with the REBEL. In this case, proceed to the connection as
®
® connection.
or iPad "Devices" menu
® ®
unit.
®