Table of Contents
Advertisement
OWC1811QC
Program Parameters are NOT controller default values.
LAC.........................
AAA or - - - .........
CON.........................
TO CHECK THE NUMBER OF HOURS ON THE UNIT
1) Disconnect unit power, and reconnect unit power.
2) When "888" appears in display,
button
3) The first set of numbers displayed reads thousands of hours:
02 = 2000, 04 = 4000 hours, 00 means less than 1000 hours.
4) The second set of numbers read hours directly:
58 = 58 hours. 742 = 742 hours.
6) Add the 2 number sets together to get total hours.
TOTAL HOURS REPRESENTS COMPRESSOR "RUN" TIME
OWC PROGRAM SETTINGS
MODEL
NOTICE
They are Oceanaire Factory Settings
DISPLAY FAULTS
Low AC line power
Failed Air Sensor (unit will not run)
Failed Condensate Pump/Over-Flow Alarm
High Pressure Cut-Out—Low/interrupted condenser
water supply. Correct problem, and re-set unit at
HP RESET
03 and 486 = 3486 hours.
01 and 59 = 1059 hours.
14
CODE SETTINGS
P1 = 80, P2 = 50
push and release the arrow down
Advertisement
Table of Contents
