Casio EA-200 User Manual page 31

Activity: Operating the Equipment Activity: Operating the Equipment
í Measuring Data
u Prepare the Voltage Measurement Setup. At the same time you start the measurement
operation, move the switch to "ON" to connect the power supply.
u Wait until the circuit achieves a steady state.
Switch
1
Power Supply
2
Connected
3 Power Supply Cut
u Prepare the Voltage Measurement Setup. At the same time you start the measurement
operation, move the switch to "OFF" to disconnect the power supply.
u Wait until the circuit achieves a steady state.
Switch
1
2 Power Supply
Connected
3 Power Supply Cut
u Perform the above operation for the RC series circuit and the RL series circuit.
u Read and check the RC and R/L values from the graph.
2-9-2
English
í Calculator Operation
u Perform the following operation to prepare for voltage measurement using the voltage
probe.
Using E-CON
m"E-CON"w1(SETUP)b(Wizard)w
1(CASIO)b(Volt) 0.02w255w1(YES)
Using a Calculator Program
Find the applicable program in the Program Library (P.2-16-3), input it into your calculator,
and then run it.
u Graph results for when the power supply is connected and for when it is disconnected.
Other Things To Do
55555555555555555555555
u It appears as if combining the curve during capacitor charging and the curve
during capacitor discharging will produce a straight line with no change over time.
This, however, is not necessarily so. Consider the reason for this.
u In the case of the coil voltage curves as well, it appears as combining them as
expressions should produce a straight line. However, this also does not happen.
Consider the reason for this.
u Change the resistor, capacitor, and coil and find out how the voltage is affected.
u While the capacitor is charged, cut off the power supply and observe changes in
capacitor voltage with the circuit left open. Compare what you observe with the
change in voltage when the circuit is closed.
5555555555555555555555
20020601
Measurement Measurement
Voltage Change when Power Is Connected
Voltage Change when Power Is Disconnected