Unpacking; About The Ea-200; Before Using The Ea-200 For The First Time - Casio EA-200 User Manual

Unpacking

EA-200 Soft case
Temperature probe Optical probe
Four AA-size alkaline batteries AC adaptor
Using the Soft Case
2
1
0-3
English

About the EA-200

The EA-200 is a digital device that makes it possible for you to sample data connected with
Data communication cable
everyday natural phenomena.
(SB-62)
Data You Can Sample with the EA-200
Various different sensors can be used with the EA-200 to sample temperatures, light,
voltage, distance, and other data. The EA-200 supports sampling of up to 120,000 points,
and simultaneous sampling over five channels. Sampled data can be sent to a compatible
Voltage probe
Graphic Scientific Calculator, where it can be viewed and graphed.
Before Using the EA-200 for the First
Time
User's Guide (this manual)
Power Requirements
EA-200
Your EA-200 requires four AA-size alkaline batteries for power. Battery life depends on the
User's Guide
amount of time the EA-200 is left on, and the amount of current used by the connected
probe(s). A low battery indicator lamp (Batt) lights to let you know when it is time to replace
E
http://world.casio.com/edu_e/
batteries. To extend battery life, it is a good idea to use the AC adaptor for power whenever
sampling indoors.
When using the EA-200 in combination with the optional "Motion Sensor (EA-2)", be sure to
power the EA-200 using its bundled AC adaptor (AD-A60024).
Though the EA-200 can normally operate on battery power, separate AC adaptor power is
required while the optional "Motion Sensor (EA-2)" is being used.
Batteries are not loaded in the EA-200 when it is shipped from the factory. Because of this,
use the following procedure to load batteries into the EA-200 before using it for the first time.
To load batteries
20020601
1. Remove the battery cover by pulling with your finger at the
point marked 1. If there are batteries in the battery
compartment, remove all four of them.
2. Load four new AA-size batteries. Make sure that the plus and
minus ends of the batteries are facing in the directions shown
by the markings inside the battery case. Replace the battery
cover.
3. Slide the [ON/OFF] switch to turn on the EA-200. To turn off,
slide the [ON/OFF] switch again.
1