Table of Contents
Advertisement
NLRinse System
If rinse aid has spilled over, it must
3.
be removed from the rinse aid
container.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Close the lid of the rinse aid
4.
reservoir.
aThe lid audibly clicks into place.
Set the rinse aid amount
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often on
3.
until the display shows the factory
set value r05.
Just as often on
4.
the desired amount of rinse aid
has been set.
– At a low setting, less
rinse aid during the
wash cycle allowed
through the stripes
be well
28
max
Busy-
reflected
to press
press until
added, where-
on the crockery
less.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
To save the settings, press . for
5.
about 3 seconds
Switch off rinse system
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse system.
Tip:The function of the rinse aid is
limited in combination detergents. You
usually get better results by using
rinse aid.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often on
3.
until the display shows the factory
set value r05.
Just as often on
4.
the display shows r00.
To save the settings, press . for
5.
about 3 seconds
aThe rinse aid system is
switched on and the rinse aid refill
indicator is deactivated.
to press.
Busy-
reflected
to press
press until
to press.
Advertisement
Table of Contents
