Table of Contents
Advertisement
NLSoftening System
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
Only fill the water softener
▶
reservoir with dishwasher
softening salt.
†The rinse aid container can be
corrode softening salt.
To ensure that spilled softening
▶
salt is rinsed out of the rinse aid
container, fill the softening salt
into the softening salt reservoir
immediately before the program
starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
3. NoteOnly use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
1
Funnel
The reservoir for softening salt
fill completely with softening salt
len. The water in
him is displaced e
Depending on the
1
26
a
t reservoir
n flows away.
device version
Fit and close the lid of the
4.
reservoir.
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the indicator.
Note
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
†The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
†The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often on
3.
the display shows H00.
To save the settings, press . for
4.
about 3 seconds
aThe water softener has been
switched on and the refill
softener salt indicator is
deactivated.
Busy-
reflected
press until
to press.
Advertisement
Table of Contents
