Table of Contents
Advertisement
Deg
Rad
unit for value input and calculation result display.
Note: In this manual, the
degrees, while the
Fix
Sci
calculation result.
Fix: The value you specify (from 0 to 9) controls the number of decimal
places for displayed calculation results. Calculation results are rounded off
to the specified digit before being displayed.
Example:
Sci: The value you specify (from 1 to 10) controls the number of significant
digits for displayed calculation results. Calculation results are rounded off to
the specified digit before being displayed.
Example:
Norm: Selecting one of the two available settings (Norm 1, Norm 2)
determines the range in which results will be displayed in non-exponential
format. Outside the specified range, results are displayed using exponential
format.
–2
Norm 1: 10
Example:
ab/c
fraction (d/c) for display of fractions in calculation results.
STAT
(frequency) column in the STAT Mode Stat Editor.
Rdec
results using recurring decimal form.
Disp
a comma for the calculation result decimal point. A dot is always displayed
during input.
Note: When dot is selected as the decimal point, the separator for multiple
results is a comma (,). When comma is selected, the separator is a
semicolon (;).
CONT
Contrast" for details.
Initializing Calculator Settings
Perform the following procedure to initialize the calculator, which returns the
calculation mode to COMP and returns all other settings, including setup
menu settings, to their initial defaults.
(CLR)
Gra
Specifies degrees, radians or grads as the angle
symbol indicates radians.
Norm
Specifies the number of digits for display of a
100 ÷ 7 = 14.286 (Fix 3)
14.29
1 ÷ 7 = 1.4286
1.429
x
x
10
|
|, |
|
10
1 ÷ 200 = 5
0.005
d/c
Specifies either mixed fraction (ab/c) or improper
ON ;
OFF
ON ;
OFF Specifies whether or not to display calculation
Dot ;
Comma
Adjusts display contrast. See "Adjusting Display
(Setup)
(Yes)
symbol next to a sample operation indicates
(Fix 2)
–1
10
(Sci 5)
10
–1
(Sci 4)
–9
Norm 2: 10
–3
10
(Norm 1)
(Norm 2)
Specifies whether or not to display a FREQ
Specifies whether to display a dot or
E-6
x
x
10
|
|, |
|
10
Hide quick links:
Advertisement
Table of Contents
