Advertisement
Tools handy for assembly process: Phillips head screwdriver, 11/32" spin-tite or socket, 7/16" end
wrench or socket. The elements of the antenna are pre-assembled from the factory.
1
Step 1:
Start with the rear boom section
(1" x 36") assembly.
4
Step 4:
Attach the rear boom section to the
front boom section using the supplied
8-32 x 1 1/4" screws and nylock nuts.
M2 ANTENNA SYSTEMS, INC. 4402 N. SELLAND AVE. FRESNO, CA 93722 TEL 559.432.8873 FAX 559.432.3059 WEB: WWW.M2INC.COM
917A-ISP MANUAL
GETTING STARTED
2
Step 2:
Attach the folded dipole to the rear
boom section by sliding the unit back
and forth until it is in place.
5
Step 5:
Attach the mounting U-bolt and Cradle
in the correct polarity holes. Use the
two 1/4-20 hex nuts and lock washers.
It is highly recommended to use a
lubricant like WD-40 on the threads of
the U-bolt. Stainless material will seize
if not lubricated.
8.9.07
3
Step 3:
Attach the driven dipole with a single
8-32 x 1 1/4" screw.
Advertisement
