Page 2
- Drywall Hand Saw - Miniature Flat Blade Screwdriver for Point Source Speakers SPEAKER PLACEMENT (ALX2PS / ALX3PS / ALX5.25IC / ALX6.5IC / ALX6.5IC DM / ALX8.0IC) These speakers are designed to operate in a standard drywall or suspended acoustical panel ceiling.
Page 3
3. Use a drywall saw or other appropriate tool to carefully cut out the speaker holes. The cut-out is the exact size required for the speaker. You also can go as much as 1/4” over this size as “Mistake Room”.
Dry Wall or Ceiling Tile Note: As you turn the Dog-Ear screws clockwise, the Dog-Ear Clamps will swing out away from the speaker (1A). Continue to turn the screw and the Dog-Ear Clamps will Lower down until they reach the mounting surface (1B)
Page 5
For the ultimate in Hi Fidelity sound quality, check out the MB QUART 5.1 speaker systems (tower speakers, center channel and book shelf speakers) in several classic and modern finishes.
Page 6
DIAGRAM 5 To amplifier or surround sound receiver 8-Ohms DIAGRAM 6 Drywall (1B) Dog Ear Clamp Dog Ear Dog Ear Screw Clamp (1A)
Page 7
- If you do not have the installation cut-out template, the cut-out dimensions are also located on the speaker label located on the side of the speaker. You can also down load the template by going to our web site at: www.maxxsonics.com - The speaker trim bezels and grilles can also be spray painted.
All damages resulting from insufficient packing are the sole responsibility of the products owner. Proof of purchase in the form of a Bill Of Sale or receipted invoice, issued by an authorized MB Quart dealer is always required for any and all warranty related services.