The Stage Fogger DMX is a Microprocessor Controlled, Water Based Fog Generating System. Microprocessor Control The Stage Fogger DMX features microprocessor control. From temperature regulation to taper back flow control, all of the functions are monitored and processed by the on-board processor.
Power Rating: 110 Volt A.C.50/60 Hz 13 Amps 240 Volt A.C. 50/60 Hz. 6.5 Amps. 240 Volt A.C.50/60 Hz 6.5 Amps Fluid: Ultratec Water Base Fog Fluid Includes: Full Timer Remote Included: Full Timer Remote RCT Replacement Kit On-Board DMX...
Operating Procedure 1. The Stage Fogger DMX must only be connected to a grounded receptacle capable of sustaining at least 12 Amps. The supply should be ‘clean’ and free of interference. 2. Open a container of Ultratec Special Effects fog fluid, remove cap and break foil seal (if provided). Remove cap from Stage Fogger DMX fluid resevoir.
The Stage Fogger DMX comes equipped with onboard DMX Control as a standard feature 1. Plug in the 5 pin DMX cable into the DMX IN connector located on the rear of the Stage Fogger DMX. A terminator may be required if the DMX OUT is not used.
Warning: Ultratec Special Effects Inc. considers all of it’s product to be safe for use in the application it was intended. Ultratec Special Effects takes no responsibility for misuse or incorrect use. Always refer to the Product Manual for proper use.