Installing The Led Assembly And Glass Shade - Hinkley COLLIER 54 Instruction Manual

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

NOTE: Be sure the power is off before installing.
Remove one of the three screws on the adapter plate located
1
on the fan motor. Loosen the other 2 screws. (Do not remove)
2
While holding the LED assembly under your fan, make the
polarized plug connections:
- Red to white
- Black to black
3
Tuck connections neatly into adapter plate. Place the key
holes on the LED assembly over the 2 screws previously
loosened, turn the LED assembly until it locks in place at the
narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed.
Remove the 4 decorative knobs from the Adapter plate. Raise
4
the shade assembly against the adapter plate and secure
using the four decorative knobs previously removed.
5
Restore power and your LED assembly is ready for operation.
12 | hinkley.com
Wire connectors
LED
assembly
Shade
Assembly
Adapter
Plate
Screws