Remove The Bottom Motor Housing; Installing The Blades - Hinkley COLLIER 54 Instruction Manual

REMOVE THE BOTTOM MOTOR HOUSING

INSTALLING THE BLADES

10 | hinkley.com
Upper
motor housing
Bottom
motor housing
Screws
Screws
Blade
support
plates
Blades
Blade Arms
Screws
REMEMBER to turn off the power before you begin.
Remove the bottom motor housing by remove the four mounting
screws on the upper motor housing.
NOTE:
Remove any rubber supports that are installed for
shipping.
Before install the blade arms need to remove the lower bottom
motor housing. Place the screws through the holes in the blade
support plates. Repeat this procedure without tightening the
screw until all 3 screws have been started into the blade arm.
Insert the blade through the slot on the housing. Align the holes
on the blade and the fan motor assembly and secure with screws.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.