Installing The Switch Housing - Hinkley Grander 900672F Instruction Manual

INSTALLING THE SWITCH HOUSING

Mounting plate
Fig. 1
1
Remove the 1 of 3 screws from the mounting hub and keep it
for future use. Loosen the other 2 screws. (Do not remove)
Place the key holes on the mounting plate over the 2 screws
2
previously loosened from the mounting hub , turn mounting
plate until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened
and the one previously removed. (Figure 1)
Mounting Hub
(bottom of motor)
Screws
Detachable Switch
Housing
Fig. 2
1
Remove 3 screws from the mounting plate.
Install the Detachable Switch housing assembly to the mounting
2
plate with four screws previously removed.
Mounting Plate
Screws
©2019 Hinkley Lighting, Inc. | hinkley.com | 11