Table of Contents
Advertisement
HARDWARE PREPARATION AND INSTALLATION
Figure 2-1. M68MPB916R3 (C version) Parts Location Diagram (top view)
2-2
Depending on your application, it may be necessary to cut the W2
wiring trace short (cut-trace short). Be careful not to cut adjacent
PCB traces, nor cut too deep into the multi-layer circuit board.
If the cut-trace short on a jumper header is already cut, you can
return the MPB to its default setting by installing a user-supplied
fabricated jumper.
CAUTION
M68MPB16R3UM/D
Advertisement
Table of Contents
