Sunnydaze Decor GSI-274 Assembly Instructions

Parts:

A. Basin- 1 pc

B. Pump and transformer- 1 pc

C. Lid- 1pc

D. Fountain body- 1pc

E. Clock- 1pc

F. Splash guard- 1 pc

G. Connector Bolts

H. Pebbles-1 bag

Assembly Instructions:

1. Insert the pump into the basin and connect the pump to the

hose.

2. Plug the pump cord into the transformer.

3. Connect the lid to the fountain body.

4. Connect the lid and fountain body to the basin.

5. Place the clock onto the fountain body.

6. Connect the splash guard to the middle of the lid.

7. Put the pebbles in the basin.

8. Plug the power cord into an electrical outlet.

• The pump and light are tested and approved for indoor use

only.

• Keep fountain out of reach of children.

• Use proper power source as indicated on water pump label.

• Keep electrical cords away from all heat sources.

• Do not place electrical cords in high temperatures.

• Check water level at pump location regularly. Make sure that

the pump is fully submerged to avoid damaging the pump.

GSI-274

Table of Contents

Do you have a question about the GSI-274 and is the answer not in the manual?

Page 1 GSI-274 Parts: A. Basin- 1 pc B. Pump and transformer- 1 pc C. Lid- 1pc D. Fountain body- 1pc E. Clock- 1pc F. Splash guard- 1 pc G. Connector Bolts H. Pebbles-1 bag Assembly Instructions: 1. Insert the pump into the basin and connect the pump to the hose.
Page 2 Troubleshooting: • Pump operates but no flow: Make sure pump is fully submerged into the water. If there is still no water, turn off the transformer and repeat this step. • Water speed: You can adjust the speed of the water flow by using the switch control located on the pump housing.