Table of Contents
Advertisement
About This Guide
Copyright © 2011, Juniper Networks, Inc.
This guide contains information that you need to install and configure the SRX3600
Services Gateway quickly. For complete installation instructions and instructions on
installing additional modules such as cards and power supplies, see the SRX3600 Services
Gateway Hardware Guide at
WARNING: This guide contains a summary of safety warnings in "Safety
Warnings" on page 24. For a complete list of warnings for this device, including
translations, see the SRX3600 Services Gateway Hardware Guide at
http://www.juniper.net/techpubs/
The SRX3600 Services Gateway is a high-performance, scalable, carrier-class security
device with multiprocessor architecture. The services gateway has a capacity of up to
30 gigabits per second (Gbps), full duplex. The services gateway is 5 rack units (U) tall.
Nine services gateways can be stacked in a single floor-to-ceiling rack, for increased port
density per unit of floor space. The services gateway provides 12 Common Form-factor
Module (CFM) slots that can be populated with up to seven Services Processing Cards
(SPCs), up to three Network Processing Cards (NPCs), and up to six I/O cards (IOCs).
The services gateway also has one dedicated slot for the Switch Fabric Board (SFB), one
slots for a Routing Engine, one slot for an SRX Clustering Module (SCM), four slots for
power supplies, and one slot for the fan tray and air filter.
Figure 1 on page 3 and Figure 2 on page 4 show the front and rear of the SRX3600
Services Gateway.
Figure 1: Front View of the SRX3600 Services Gateway
Management
USB
Ethernet port
Console
ports
port
SFB
Slot
ESD
IOC in
CFM slots
number
point
slot 1
for IOCs
guide
and SPCs
http://www.juniper.net/techpubs/
.
About This Guide
.
Cooling
air exhaust
3
Advertisement
Table of Contents
