Returns 1-32; Rear Panel; Power Switch; Power Receptacle - Mackie DS3232 Digital Snake Owner's Manual

5. RETURNS 1-32

These are male XLR connectors that provide balanced
line-level signals.
The XLR outputs are wired as follows:
Pin 1 = Shield or ground
Pin 2 = Positive (+ or hot)
Pin 3 = Negative (– or cold)
Like the inputs, the routing for the 32 returns on the
DS3232 is configured by the mixing console. Generally,
this will be done in the Setup window for the expansion
cards where the U100 Network card is installed. In the
case of the TT24, there is no configuration required for
the returns.

Rear Panel

All the connection points (other than the power cord)
are located on the front panel for easy accessibility when
rack mounted.

6. POWER Switch

This one is self-explanatory. When the POWER switch
is turned ON, power is supplied to the DS3232 and the
POWER LED on the front panel lights up.
Press the bottom of this switch to put the DS3232
into standby mode. It will not function, but the circuits
are still live. To remove AC power, either turn off the
AC mains supply, or unplug the power cord from the
DS3232 and the AC mains supply.
DS3232
8
DS3232 DIGITAL SNAKE
24-BIT / 96kHz DIGITAL SNAKE

7. POWER Receptacle

This is a standard 3-prong IEC power connector. Con-
nect the detachable linecord (included in the box with
your DS3232) to the power receptacle, and plug the oth-
er end of the linecord into an AC outlet. The DS3232 has
a universal power supply that can accept any AC voltage
ranging from 100 VAC to 240 VAC. No need for voltage
select switches. It will work virtually anywhere in the
world. That's why we call it a "Planet-Earth" power sup-
ply! This also means that it is less susceptible to voltage
sags or spikes, providing greater electromagnetic isola-
tion and better protection against AC line noise.

8. Fan

The DS3232 is fan-cooled and brings air in through
the sides and out through the rear. Make sure that cool
air is available at the sides of the unit, and that there
is room at the rear for the warm air to exit from the
enclosure and dissipate. If rack-mounted, make sure
the DS3232 is not pulling warm (or hot) air in from the
rack, and that the sides and rear are not obstructed.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
RISK OF
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
ELECTRIC SHOCK AVIS:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
SERIAL NUMBER MANUFACTURING DATE
POWER