Table of Contents
Advertisement
DS3232 Features
Front Panel
All the connection points (other than the power cord)
are located on the front panel for easy accessibility when
rack mounted.
1. Network Connection
This RJ45 connector transfers the digital audio and
control data between the DS3232 and the mixing con-
sole. Use a standard Cat5e Ethernet cable to make this
connection.
This is a Neutrik ® EtherCon ® connector that
features a secure latching system when used with the
Neutrik male cable carrier for preassembled RJ45 plugs.
2. POWER Indicator
This green LED lights up when the POWER switch is
turned on and the linecord is attached and plugged into
an AC power source.
3. COMM
Indicator
This LED lights up to indicate that communication is
established between the DS3232 and the mixing console
via the U100 Network card.
DS3232
24-BIT / 96kHz DIGITAL SNAKE
1
2
3
PUSH
PUSH
PUSH
17
18
19
PUSH
PUSH
PUSH
1
2
3
17
18
19
U-NET
PUSH
4
5
6
7
PUSH
PUSH
PUSH
PUSH
20
21
22
23
PUSH
PUSH
PUSH
PUSH
4
5
6
7
20
21
22
23
4. INPUTS 1-32
These are female XLR connectors, which accept a
balanced microphone input from almost any type of
microphone. The microphone preamps feature our latest
remote-controlled design, with higher fidelity and headroom
rivaling most standalone mic preamps on the market today.
The XLR inputs are wired as follows:
Pin 1 = Shield or ground
Pin 2 = Positive (+ or hot)
Pin 3 = Negative (– or cold)
These XLR connectors are also equipped with 48V
phantom power, which can be turned on and off from
the mixing console.
The routing of the 32 inputs on the DS3232 is config-
ured by the mixing console. Generally, this will be done
in the Setup window for the expansion cards where the
U100 Network card is installed.
If you are connecting a line-level signal to one of the
inputs, engage the PAD for that input. This reduces the
input sensitivity of the mic preamp so it can accept a
line-level signal. Also, make sure that phantom power
isn't turned on for that channel. It could damage the
output stage of the line-level device you have connected
to the XLR balanced input.
Note: Phantom power should only be
used with microphones designed to
accept it.
POWER
INPUTS
8
9
10
11
PUSH
PUSH
PUSH
PUSH
24
25
26
27
PUSH
PUSH
PUSH
PUSH
RETURNS
8
9
10
11
24
25
26
27
12
13
14
15
PUSH
PUSH
PUSH
PUSH
28
29
30
31
PUSH
PUSH
PUSH
PUSH
12
13
14
15
28
29
30
31
Owner's Manual
16
PUSH
32
PUSH
16
32
7
Advertisement
Table of Contents
