Table of Contents
Advertisement
Retainer Lip Parts List
Assembly of Retainer Lip
1.
Position ITEM 2 flush to bottom edge of the top and flush to each end. Mark the holes on the wood top and drill 3/4"
deep with 5/32" drill bit. Install Item 2 using the supplied screws(ITEM3). Do not overtighten.
2.
Position Item 1 flush to bottom edge of the top and with the return lip sitting inside of ITEM 2. Mark the holes on the
wood top and drill 3/4" deep with 5/32" drill bit. Install ITEM 1 using the supplied screws(ITEM3). Do not overtighten.
3.
Repeat Step 2 for opposite End Plate(ITEM 7).
4.
Fasten the Back Plate to the End Plates as shown in Detail C Using the supplied fasteners, ITEM 6, ITEM 5, ITEM 4
5.
This completes the assembly of the Retainer Lip.
3
1000615 - Screw, #14 X 3/4
4
1000514 - Screw, #10-24 x 1/2"
5
1000456 - Washer, #10
6
1000159 - Nut, Locking, #10-24
THIS DOCUMENT IS CONFIDENTIAL AND PROPRIETARY
PART NO. 1000590
8
Advertisement
Table of Contents
