Removing An Nvme M.2 Carrier Card And Flash Module - IBM Power System 5105-22E Manual

Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Figure 14. Removing the service access cover
Removing an NVMe M.2 carrier card and flash module from the 5105-22E,
9008-22L, 9009-22A, or 9223-22H system
To remove an NVMe M.2 carrier card and flash module from the system, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Lift each air baffle (A) straight up.
See Figure 15 on page 21.
Place air baffles upside down on a clean area. When you turn an air baffle over, hold the detachable
drive cover to prevent it from coming loose.
20 Power Systems: NVMe M.2 carrier cards and flash modules