Changing The Neck - Bernard T-Gun 445-45 Owner's Manual

7-3 Changing the Neck

1. Remove liner from gun. See section 7-4 Changing the Liner on
page 18.
2. Twist handle locking caps.
3. Pull handle caps away from handle.
4. Remove Phillips screw.
5. Separate handle.
6. Remove switch from nest in handle.
7. Unthread power cable.
8. Cut off water line and conduit clamp and pull hoses off barbed
fittings.
9. Slide on new clamps on water line and conduit.
10. Thread power cable on connection and tighten.
11. Push water line and conduit all the way to the base of the
fittings and clamp.
12. Reposition handle and switch.
13. Reinstall handle locking caps and screw.
TG408-1.2
Figure 7-B
Figure 7-C
Figure 7-D
17