6-3 Changing the Neck
1. Remove liner from gun. See section 6-4 Changing the Liner on
page 18.
2. Remove two switch housing screws with a 5/16" (8 mm) nut
driver.
3. Slide handle back.
4. Unthread power cable.
5. Cut off water line and conduit, cut off clamps and pull hoses off
barbed fittings.
6. Slide clamps on water line and conduit.
7. Thread power cable on and tighten.
8. Push water line and conduit on all the way to the base of
fittings and crimp.
9. Reposition the handle and place switch in housing, nest
housing in handle and tighten screws.
TG008-1.0
Figure 6-C
Figure 6-D
Figure 6-E
17