Installation In The Car - BABY MONSTERS Apolo Manual

17. The infant car seat is not suitable for baby sleeping for long time, please use the baby bed
instead.
18. Please contact with distributor or manufacturer to replace or supplement the components if
they were damaged or missed.
Adjustment
A. adjust the carrying handle
- To adjust the carrying handle, simultaneously press the left and right buttons(1) under both
ands of carry handle you can lock the carrying hand in place in 3 positions:
a. Vehicle position in the car or carry position outside of the car.
b. Cradle position in the desk or lock position attached with stroller.
c. Rest position in the desk or the position to put the baby into carrier.
- Loosen shoulder belts by pressing the adjustment button on central adjuster and simultaneously
pulling both shoulder belts up upon picture.
B. Pull the harness belt from the hole and insert them to the hole in higher or lower
position to adjust the harness.

Installation in the car

C. Place the infant car seat facing the rear of the vehicle on the vehicle seat. The seat is
not suitable for use with a two-pointed or lap seatbelt. Securing with a two-point seatbelt
could result in serious or fatal injuries to the child in the event of an accident. Loosen
shoulder belts by pressing the adjustment button on central adjuster and simultaneously
pulling both shoulder belts up.
ders and ensure the shoulder belts are not twisted. Place both buckle tongues together
and lock them in place in belt buckle with an audible "CLICK".
E. Pull cautiously on central adjustment belt in order to tighten shoulder belts until they
F. Pull out the vehicle seatbelt and route it over the infant car seat. Lock the buckle
tongue in place in vehicle seatbelt.
Warning: it may be that buckle part of the car seatbelt is too long so that it reaches the
blue belt guides of the infant car seat. this means that the infant car seat cannot be
fastened tightly. If this is the case, choose another seat in the car for the infant car seat.
-
English