Driver Installation For Mac Os X - Linksys USB300M User Manual

Chapter 2

Driver Installation for Mac OS X

NOTE: Do not click Cancel at any time during
the installation process. Doing so will prevent
your driver from being properly installed on
your computer.
1. If you have not yet done so, start your computer.
2. Connect the Adapter to your computer. Refer to
Installing the Adapter, page 3.
3. The operating system will automatically detect the
Adapter. When the message A new network interface
has been detected appears, insert the Installation
CD into your computer's CD-ROM drive. Then click
Network Preferences.
A new network interface has been detected
Network Preferences screen appears. The left side of
4. The
the screen contains a list of your computer's network
interfaces. The Adapter's interface will be listed as USB
Ethernet. Click Advanced to configure the interface's
settings.
Network Preferences—Connected
USB Ethernet Adapter
TCP/IP tab, and then set the following
5. Select the
properties as indicated.
Configure IPv4 Set this to Using DHCP.
Configure IPv6 Set this to Automatically.
Advanced Network Preferences—TCP/IP tab
Ethernet tab, and then set the following
6. Click the
properties as indicated.
Configure Set this to Automatically.
Advanced Network Preferences—Ethernet tab
7. Click OK to save the property settings and close the
Network Preferences screen.
Congratulations! The installation of the USB Ethernet
Adapter is complete.
For more information about networking under OS X,
refer to your Mac OS X documentation.
Configuration
8