Grizzly T32713 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com

Introduction

The Model T32713 Negative Pressure Gauge Kit
can be installed on the Model G0860, G0861, and
G0862 dust collectors to indicate when to clean or
replace the canister filter.
To reduce your risk of
serious injury, read this
entire
using machine.
Figure 1. Model T32713 Negative Pressure
Gauge Kit.

Inventory

Box Contents (Figure 2)
A. Pressure Gauge Assembly ......................... 1
B. Clear Tube
⁄ " x 24" ................................... 1
1
2
C. Hose Clamps
⁄ " ........................................ 2
1
2
D. 90º T-Fitting
⁄ " x 1
1
2
E. Dust Hose 1
⁄ " x 4
1
2
F.
Hose Clamps 1 ⁄
1
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
manual BEFORE
⁄ " x 1 ⁄ " ...................... 1
1 1
2 2
⁄ " ................................. 1
3
4
" ...................................... 2
2
COPYRIGHT © AUGUST, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
(FOR MODELS MFD. SINCE 08/21) #CS22017 PRINTED IN TAIWAN
NEGATIVE PRESSURE GAUGE
KIT FOR G0860/G0861/G0862
DUST COLLECTORS
A
D
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.

Installation

Use the following steps to assemble the Model
T32713 and attach it to your Model G0860,
G0861, or G0862 dust collector.
Qty
Items Needed
Wrenches or Sockets 10mm ............................ 2
Phillips Head Screwdriver #2 ............................ 1
MODEL T32713
INSTRUCTIONS
B
E
Figure 2. Inventory.
NOTICE
Wear safety glasses during
the entire setup process!
C
F
Qty
V1.08.21