Advertisement
UK
1.0 - INTRODUCTORY NOTE
Dear Customer, thank you for purchasing this Gemini product designed and manufactured
specifically for 2-wheeled vehicles. The 'bike finder' comes in 2 versions and is supplied with
1 remote control 748USA.
726:
6-wire bike-finder/automatic seat opener (extra wire for learning new remote controls).
726/5:
5-wire bike-finder/automatic seat opener.
USER MANUAL
2.0 - OPERATING PROCEDURE (726 & 726-5)
REMOTE SEAT OPENER: To automatically unlock the seat catch, press button "1" for
approx. 1 sec. The seat actuator will trigger the lock mechanism and the turn indicators
will flash once.
BIKE FINDER MODE: The bike finder mode is particularly useful in a crowded parking lot.
To access the bike finder mode, while within range of your bike (approx. 50m), proceed as
follows:
1. Press remote control button "2".
2. Turn indicators will flash twice.
3. If you press and hold button "2", the turn indicators will flash until the button is released.
3.0 - REMOTE CONTROL 748USA
BUTTON 1:
SEAT OPENER
BUTTON
3
:
N/A
The remote control has a low charge battery indicator that gives early warning to avoid
malfunctioning. When the batteries are low, the LED will blink when one of the buttons is
pressed. Replace batteries as follows:
2
1
2
1
Use only 2 CR2016 coin batteries and place them both (+) positive side up as shown
above.
Inserting the batteries the wrong way and/or using different type batteries can
damage the remote control or cause the batteries to explode.
Discard used batteries properly in special dedicated containers.
PAGE 02
BUTTON
2
:
BIKE FINDER MODE
BUTTON
4
:
N/A
3
3
4
4
2x
4.0 - ENERGY SAVER FEATURE "STANDBY MODE"
In order to preserve battery life, the system automatically reverts to standby mode after 3
min. of inactivity. The receiver will wake up every 3 sec. and stay in active mode for 0.2 sec.
before going back to sleep.
To wake up the system press remote control button "1" or "2" for approx.3 sec.
5.0 - HOW TO LEARN A NEW REMOTE CONTROL
The device memory will only store 4 remote controls.
!
Saving an extra device will automatically delete the first one.
To learn a new remote control proceed as follows:
!
Cycle ignition key "OFF" and "ON" 5 times in a row.
!
Within 5 sec., simultaneously press, twice in a row, remote control buttons "1"and "2".
!
The turn indicators will flash once to confirm that the new remote control has been
paired.
!
To pair another remote control, repeat the above steps.
To learn a new remote control proceed as follows:
!
Disconnect and immediately reconnect the motorcycle battery.
!
Within 5 sec., simultaneously press, twice in a row, remote control buttons "1" and "2".
!
The turn indicators will flash once to confirm that the new remote control has been
paired.
!
To pair another remote control, repeat the above steps.
6.0 - TECHNICAL SPECIFICATIONS
Power supply 726 & 726/5
Average current absorption in energy saver mode
Radio frequency
Drive current for turn indicator lamps
Drive current for seat unlock actuator
Reception (free field range)
Protection Index
7.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device falls within the scope of the WEEE Directive in force.
726
726/5
9-16 Vdc
0.35 mA
433.92 MHz
6 + 6A
6A continuous
50m
IP67
USER MANUAL - PAGE 03
Advertisement
