End-Product Labeling Requirements; Fcc Additional Testing, Part 15 Subpart B Disclaimer - Embedded Planet epConnected Asset Product User Manual

Embedded Planet, Inc.
18.8.

End-Product Labeling Requirements

The Chronos module contains an ME310 module which has an FCC ID label on it pertaining to its FCC
certification. Consequently, with Chronos used in the epConnected Asset device, the OEM host end product
manufacturer must display a label referring to the enclosed module. The exterior label will read as follows:
Device Uses Approved Radio: ME310G1-W1
Contains FCC ID: RI7ME310G1W1
Contains IC: 5131A-ME310G1W1
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
18.9.

FCC Additional Testing, Part 15 Subpart B Disclaimer

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules)
listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules
that apply to the host not covered by the modular transmitter grant of certification. If the grantee markets their
product as being Part 15 Subpart B compliant (when it also contains unintentional-radiator digital circuity), then
the grantee shall provide a notice stating that the final host product still requires Part 15 Subpart B compliance
testing with the modular transmitter installed. The end product with an embedded module may also need to
pass the FCC Part 15 unintentional emission testing requirements and be properly authorized per FCC Part 15.
Embedded Planet, Inc. | 31225 Bainbridge Rd Suite N, Solon, OH 44139 | 216-245-4180 | www.embeddedplanet.com | Page 36 of 37
epConnected Asset | Product User Manual Document Version: 1.0.0 | 26 Jan 22