Remove the system board and fingerprint reader cable
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the battery pack" on page 29
"Remove the 2242 solid-state drive and bracket (for selected models)" on page 30
"Remove the 2280 solid-state drive (for selected models)" on page 32
"Remove the heat sink" on page 34
"Remove the fans" on page 35
"Remove the I/O board with cables" on page 36
Step 1.
Disconnect cables connected to the system board.
Figure 17. Disconnect cables
Step 2.
Remove nine screws and then remove the system board.
.
Chapter 4
Removing a FRU or CRU
39