Remove The 2280 Solid-State Drive (For Selected Models); Remove The Antenna Module - Lenovo Yoga 9i Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
replacement part:
2242 solid-state drive
2242 solid-state drive bracket

Remove the 2280 solid-state drive (for selected models)

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
Step 1. Disconnect the battery pack cable from the system board. Then, remove one screw and remove
the solid-state drive by pulling it away from the slot.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 8. Remove the 2280 solid-state drive
Screw specifications
M2 x L2.5
Note: Thermal pad is provided on the lower surface of the 2280 solid-state drive. If you replace the
2280 solid-state drive, ensure that the thermal pad is attached in place.
Go to
https://support.lenovo.com/partslookup
replacement part:
2280 solid-state drive

Remove the antenna module

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
Step 1. Disconnect the battery pack cable from the system board.
32
Yoga 9i (14", 7)Hardware Maintenance Manual
to look up the Lenovo part numbers of the following
Number of screws
1
to look up the Lenovo part numbers of the following