Remove the fingerprint reader board bracket and fingerprint reader
board with cable
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the battery pack" on page 29
Step 1.
Remove one screw and the fingerprint reader board bracket. Then, peel off the keyboard connector
mylar.
Figure 18. Remove one screw and the fingerprint reader board bracket, peel off the keyboard connector mylar
Screw specifications
M2 × L2
Step 2.
Disconnect the fingerprint reader board cable from the system board. Then, remove the fingerprint
reader board with cable.
Number of screws
1
.
Chapter 4
Removing a FRU or CRU
39