Panel Descriptions; Top Panel - Roland FANTOM-06 Owner's Manual

Panel Descriptions

Top Panel

2
1
Controller section
1
Controller Explanation
You can assign various parameters or
functions to these wheels. To use the assigned
function, move a wheel while you perform.
WHEEL1
WHEEL2
If you operate the controller while holding
down the [SHIFT] button, the setting screen
appears.
Various parameters or functions can be
assigned to these buttons.
[S1] [S2] button
Hold down the [SHIFT] button and press one
of these buttons to access a screen that lets
you assign a function.
Pitch bend/modulation
This allows you to control pitch bend or apply
lever vibrato.
2 Zone section
Controller Explanation
[MASTER VOLUME] Adjusts the volume that is output from the
knob
MAIN OUT jacks and the PHONES jack.
If you press the button to make it light, control
knobs [1]–[8] adjust the pan of each zone, and
sliders [1]–[8] adjust the volume of each zone.
[PAN/LEVEL] button
Press this button while holding down the
[SHIFT] button to display the MIXER screen.
Pressing the button to make it light up lets
[CTRL] button you use control knobs [1]–[8] to control the
parameters of the current zone in real time.
Assign other functions to sliders [1]–[8] and
control knobs [1]–[8].
ASSIGN1 assigns parameters that you set for a
scene, and ASSIGN2 assigns parameters that
you edit in system settings.
Hold down the [SHIFT] button and press one
of these buttons to access a screen that lets
[ASSIGN] button
you assign a function.
How to switch between ASSIGN1 and ASSIGN2
ASSIGN1
(SCENE)
ASSIGN2
(SYSTEM)
8
3
[ASSIGN] button
[ASSIGN] button + [PAN/LEVEL]
button
5
4
Controller Explanation
Switches the zones that you're operating.
[ZONE 9-16] button Unlit:
Lit: 9–16
Select the zone that you want to control (the
current zone). The selected zone becomes the
current zone.
[ZONE SELECT] button
When ZONE SELECT is on, use the ZONE INT/
EXT [1]–[8] buttons to select the current zone.
Various parameters or functions can be
assigned to these knobs.
Control knobs [1]–[8]
The parameters that can be controlled depend
on the function select buttons located at the
left.
Specify whether the applicable zone does
sound or does not sound when you play the
keyboard. In conjunction with the current
zone, this determines how the internal sound
ZONE INT/EXT buttons
engine (external sound module) produces
[1]–[8]
sound.
When ZONE SELECT is on, the buttons operate
as ZONE SELECT [1]–[8] buttons.
Various parameters or functions can be
assigned to these sliders.
Sliders [1]–[8]
The parameters that can be controlled depend
on the function select buttons located at the
left.
[SPLIT] button Turns the split function on/off.
[CHORD MEMORY]
Turns the chord memory function on/off.
button
[ARPEGGIO] button Turns the arpeggiator on/off.
Hold down this button and use the OCTAVE
[TRANSPOSE] button [DOWN] [UP] buttons to raise or lower the
pitch range in semitone steps.
OCTAVE [DOWN] [UP]
Raise or lower the pitch range in steps of an
button
octave.
Common section
3
Controller Explanation
The WRITE screen appears.
[WRITE] button
Saves a scene or tone.
7
6
1–8