LapSafe ClassBuddy Installation Manual page 4

Step 5: Secure Rear Panel
Reconnect the earth cable you previously disconnected and refit all 10
screws back into place.
Securing to a Desk (Optional)
It is possible to secure your ClassBuddy
you will require 4 x M4 bolts (not included).
The drilling pattern is 392mm x 338mm but please allow at least 40mm
from the rear of the desk.
Remove the feet fixing screws from the ClassBuddy
through the desk into the holes from the feet fixings. Retain the feet in
order to maintain a ventilation gap.
6
Desk down to the desk. To do so
TM
Desk and secure
TM
Complete
Your new ClassBuddy Desk should now be successfully installed and
TM
ready to use. Please refer to the User Manual that is supplied with your
ClassBuddy Desk for further information. Please read the Health and
TM
Safety guidance in the User Manual.
If you have any problems please do not hesitate to contact our support
team:
Support Enquiries
lapsafe.com/support/enquiry
support@lapsafe.com
0800 130 3456
Replacement Keys
lapsafe.com/support/keys
7