Fusing Thermostat (Th6); Fusing Thermistor (Non-Contact Sensor) (S10) - Ricoh IM C300 Service Manual

Fusing
• There are two screw holes for each screw on the entrance guide plate. Use the
outer holes when tightening the entrance guide plate.
Different types of screws are used for [A] and [B]:
•
[A]: Shoulder screw
[B]: Double sems screw (a screw with a washer)

4.14.5 FUSING THERMOSTAT (TH6)

1.
Remove the fusing upper cover.
2.
Remove the fusing thermostat (TH6) [A]. (
• Never reuse an activated thermostat. Use a new thermostat for replacement.

4.14.6 FUSING THERMISTOR (NON-CONTACT SENSOR) (S10)

If the hook of the fusing thermistor (non-contact sensor) (S10) is broken, the fusing
•
thermistor (non-contact sensor) (S10) cannot be attached. Replace the entire fusing
unit in that case.
1.
Remove the fusing upper cover.
D0CA/D0C9/D0C8/D0CB
(Fusing Upper Cover)
× 2)
(Fusing Upper Cover)
4-154 SM