Table of Contents
Advertisement
Release Note
26. Problems corrected in Ver. 1.50
26.1. Saving setting for SNMP
SNMP related settings may not be saved when the version was updated or a setting was
called. This problem has been solved. When a version is to be updated from the version
prior to Ver.1.50 or the setting is to be called from the file saved in the version prior to Ver.
1.50, note down the required SNMP related setting values and reset them after the version
is updated or the setting is called.
(Problem from Ver. 1.05)
27. Problems corrected in Ver.1.34
27.1. Edge Storage
When the overwrite setting was set to ON and there were 500 entries, there was the
problem that the entry was not overwritten from the oldest one.
(Problem since Ver. 1.31)
The problem that playback was not possible with RTP/RTSP/HTTP has been corrected.
(Problem since Ver. 1.31)
There was an error in timestamp of streaming. This problem has been fixed.
(Problem since Ver. 1.10)
The Range parameter was rounded down to the whole number. This problem has been
fixed.
(Problem since Ver. 1.31)
27.2. Alarm buffer
When using the alarm buffer, the data was discarded if the post time and event occurrence
overlapped. This problem has been fixed.
(Problem since Ver. 1.05)
27.3. Streaming
Multicast's stream acquisition request failed if it was performed consecutively. This problem
has been fixed.
(Problem since Ver. 1.05)
27.4. IR illuminator (SNC-CH180/DH180/CH280/DH280)
When the IR illuminator was set to "Sync with Day/Night" and the Day/Night mode to a
setting other than "Auto", there was a case where the infrared illuminator did not work in the
Night mode. This problem has been fixed.
(Problem since Ver. 1.31)
28. Newly Added Functions in Ver. 1.32.01
28.1. Supported models
In this version, SNC-CH135 is supported.
18
Sony Corporation
Advertisement
Table of Contents
