Table of Contents
Advertisement
Release Note
solved.
(Problem from Ver. 1.50)
24.5. Incorrect value in Fragment Offset of JPEG RTP packet header
The value of Fragment Offset in JPEG RTP packet header differs from the correct one
defined by RFC 2435. This problem has been solved. For the client software which wants to
use the former incorrect value to keep compatibility, the following CGI command is provided.
http://ip_adr/command/camera.cgi?RTPMJPEGOffset=off
For details regarding this function, refer to the instructions for the CGI Command Manual.
(Problem from Ver. 1.05)
24.6. Reconnection problem on audio upload authentication error
When a network connection for audio upload from a client software causes authentication
error, the camera does not close its connection. If the client tries to reconnect by using the
same connection, it fails to reconnect. This problem has been solved.by closing the failure
connection from the camera. SNC audio upload tool close the failure connection from the
client and has no problem.
(Problem from Ver.1.05)
24.7. Play operation problem of Edge Storage
Play operation of Edge Storage may not start depending on the specified start time and end
time. This problem has been solved.
(Problem from Ver. 1.31)
25. Newly Added Functions in Ver. 1.50
25.1. NTCIP support
NTCIP (National Transportation Communications for ITS protocol) is the protocol for the
transportation monitoring standardized in the U.S.A. The registration and calling of the
preset and PTZ control are working with the VidShield software by VidSys in the U.S.A.
There is no setting item regarding this function in the Administrator menu.
25.2. Connection List
This is a function to acquire information regarding the delivery destination of the streaming.
This is used to recognize which client is receiving the streaming.
It is possible to acquire the IP address, port number, protocol using HTTP or UDP, and
detailed information, such as media type for H.264, etc., for every session.
This is supported by the CGI command. There is no setting item regarding this function in
the Administrator menu.
For details regarding this function, refer to the instructions for the CGI Command Manual.
25.3. Smartphone viewer
This is a viewer for smart phones to display an image or perform the PTZ operation by
accessing from a smart phone.
The user manual and support information for this function are at the following site.
http://www.sony.net/ipela/snc
17
Sony Corporation
Advertisement
Table of Contents
