Craftsman 850 Series Owner's Manual page 6

INSERT CABLE CLIP (See Fig. 6)
• Insert plastic cable clip into hole on the back of handle
column. Push cables into clip.
HANDLE
COLUMN
CONNECT SHIFT ROD (See Fig. 7)
• Insert end of shift rod farthest from bend into hole of
shift lever in di ca tor.
• Insert hairpin clip through hole of shift rod to secure
with bend of clip on right side.
REMOVE TILLER FROM CRATE
• adjust handle assembly to lowest position. Be sure lock
lever is tightened securely.
• Make sure shift lever indicator is in "N" (neutral) po si tion
(See Fig. 7)
• Tilt tiller forward by lifting handle. Separate cardboard
cover from leveling shield.
• Rotate tiller handle to the right and pull tiller out of
carton.
ASSEMBLY
CABLES
CABLE CLIP
FIG. 6
ATTACH THIS END TO SHIFT
LEVER IN DI CA TOR
SHIFT ROD
SHIFT
ROD
CHECK TIRE PRESSURE
The tires on your unit were overinflated at the factory for
shipping purposes. Correct and equal tire pressure is
important for best tilling performance.
• Reduce tire pressure to 20 PSI.
HANDLE HEIGHT
• Handle height may be adjusted to better suit operator.
(See "TO ADJUST HANDLE HEIGHT" in the Service
and Adjustments section of this manual).
6
SHIFT
HAIRPIN
LEVER
CLIP
INDICATOR
FIG. 7