Replacement; Encoder Replacement - HOLLISTER-WHITNEY GLV-40S1 Series Instruction Manual

Table of Contents

Advertisement

Replacement

WARNING
Have only qualified personnel perform the replacement work. The
person who performs the replacement work must make sure that the
machine power is off, and that the elevator will not move
unexpectedly.

Encoder Replacement

Required Tools & Materials:
• Encoder (ECN1313)
• Hex wrench
o 2 mm
o 4 mm
o 6 mm
o 8 mm
• Hex sockets
o 2 mm
o 4 mm
• Torque Wrench (Need to measure 9 in-lbs. and 44 in-lbs.)
• M10 bolt (at least 1" or 25 mm in length)
Section
7
Page 7-1
Rev. A - 04/01/2022

Advertisement

Table of Contents
loading

Table of Contents