Table of Contents
Advertisement
Section
5
Installation
Machine Mounting
Before hoisting the machine into place, verify all the hoisting equipment is rated for the 4500
pounds (2040 kg) weight of the machine. See Section 3.4
Provide a level, structurally supported (rated for the load on the machine) machine space with
proper clearance around the machine for maintenance and adjustments.
This machine is primarily intended to be mounted in traditional overhead applications with
down-pull forces on the traction sheave.
Traditional Overhead Mounting
Anchor the machine to the structural support surface using the (8) mounting hole locations in
the base. The hardware required to anchor the machine to the support surface should be at
least 1" diameter, grade #5 minimum, with standard washers. Hardware adhering to ASME
A325 is also suitable.
Note - Due to the varying mounting surface thicknesses, no mounting hardware is
shipped with the machine.
Figure 5
Page 5-1
Rev. A - 04/01/2022
Advertisement
Table of Contents
