tibelec 976130 Instructions Manual page 13

1. Connect the black probe to terminal COM and the red probe to terminal VΩmA
2. Set the function switch to the desired AC voltage rating
3. Connect the test plungers to the circuit and read the value displayed on screen once
it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩmA
2. Set the function switch to the desired DC voltage rating
3. Connect the test plungers to the circuit and read the value displayed on screen once
it has stabilised. When measuring DC voltage, the display shows the polarity of the
red probe.
1. Connect the black probe to terminal COM and the red probe :
to terminal VΩmA if measure <200mA
to terminal 10A if measure <10A and > 200mA
2. Set the function switch to the desired DC direct current rating
3. Connect the test plungers to the circuit and read the value displayed on screen once
it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩmA
2. Set the function switch to the desired resistance rating
3. Connect the test plungers to the circuit and read the value displayed on screen once
it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩmA
2. Set the function switch to position
3. The buzzer will sound if the resistance is ≤30Ω.
13