Table of Contents
Advertisement
Note: The formatted memory capacity is less than the raw memory capacity. To determine raw memory,
press the hidden Hydrolab key.
2. Press any key to return to the Surveyor 4a Files submenu and move to the next option.
To check individual file status, highlight Delete and press SELECT. All files will appear listed with
the file type and the corresponding size. Press the GOBACK key to prevent deleting any file.
4.3.5 Reviewing a File
This function shows the contents of any manual, time-triggered, or AutoLog file. This function can
also be used to the check the status of these file types.
1. From the Files>Surveyor 4a menu, in Series4Sonde interface mode, press the Review key.
2. Choose the file to review and press the Select key.
3. Select how to review the contents of the file, either from top (Beginning) or from a specific date
4. To return to the Beginning/Date/Time submenu, press GOBACK. TO go back to the Review
4.3.6 Annotating a File
On files have been created, comments can be added to the files. Annotate will only allow
comments to be added to manual, time-triggered, or AutoLog files.
1. From the Files from the Main Menu, in Series4Sonde interface mode, press Annotate.
2. Choose the file to annotate and press SELECT.
3. Enter any comments (up to 80 characters) and press the DONE key when complete.
4.3.7 Deleting Files
Deleting files will make more room for new files and erase unwanted stored files in the instrument
memory.
1. Select Files from the Main Menu.
2. Highlight Delete and press SELECT.
maximum number of files that can be stored in the instrument, amount of formatted memory
installed on the Surveyor 4a, the memory currently available, and number of days available
with the present amount of memory left, internal battery capacity (IBC) in percent and in days
left before the Surveyor 4a power runs out, and the external battery capacity (XBC).
and time.
a. If Beginning is selected, the information contained in the file is displayed in tabular format.
Press the DOWN arrow key to go to the previous scans.
b. If Date/Time is selected, enter the date where you want to review the data and press
DONE. The default date is the file setup date.
c. Enter the time where you want to start the review and press DONE. The default time is the
file setup time.
d. Press the UP or DOWN arrow keys to move through the file.
menu, press DONE.
Logging and Data Transfer
Surveyor 4a File Types (with Memory)
Page 21
Advertisement
Table of Contents
