Table of Contents
Advertisement
2.5 Setting the Graph Display Mode
The second display mode is a graph. The Graph/Tab key toggles between the tabular and graph
modes.
Due to the different configuration possibilities, one or more parameter may need to be added to the
tabular display to allow the graph mode. See
1. From the Main Screen, select
2. Highlight Display:Graph and press
X-Axis Configuration
2.6 Setting the Automatic Shutdown
The automatic shutdown is used to save battery life in case it is not turned off after an operation.
This feature will turn the Surveyor 4a off if no key is pressed in the programmed amount of time
following the last key pressed. Once the Surveyor 4a shuts down, power it back up using the
OFF/ON
1. From the Main Screen, select
2. Highlight Timeout:Shutdown using the cursor keys and press
3. A Timeout:Shutdown screen is displayed.
4. Enter the shutdown timeout. Select 0 (zero) to disable or select the appropriate amount of time
Note: If a mistake is made, clear entries one by one using the BACKSPACE key.
5. When all the numbers are entered, press the
2.7 Setting the Screen Saver Option
This is a power saving feature that puts the Surveyor 4a screen to sleep if no key is pressed in a
programmed amount of time following the last key pressed. If the screen shuts down, press any
key once and the screen will reappear with the last screen displayed.
If the screen save option is active while using the Surveyor 4a, up to 80% more battery life can be
saved.
1. From the Main Screen, select
2. Highlight Timeout:Display using the cursor keys and press
3. The Timeout:Display screen is displayed.
configuration choices, X-Axis, Y-Axis, and Orientation.
a. Highlight X-Axis and press Select.
b. Select the Date and Time or one of the parameters and press select.
key.
(1–255 minutes) for the specific operation using the
after each number.
SELECT
message will be displayed.
section 2.4
for more information.
.
SETUP/CAL>SETUP
. A new screen will be displayed with three graph
SELECT
>
.
SETUP/CAL
SETUP
RIGHT
key. A "Setup:Successful! Press any key"
DONE
>
.
SETUP/CAL
SETUP
Surveyor 4a Setup
.
SELECT
and
cursor keys. Press
LEFT
.
SELECT
Setting the Graph Display Mode
Page 11
Advertisement
Table of Contents
