Table of Contents
Advertisement
Surveyor 4a Setup
4. Repeat step 3 until the entire date is selected. If a mistake is made, clear entries one by one
5. When the new date is correctly entered, press the
6. The Time screen will be displayed. Use the
7. Press any key to return to the Setup submenu.
2.3 Changing the Date Format
The features specifies the date format that will be used by the Surveyor 4a software.
1. From the Main Screen select
2. Highlight Date:Format using the cursor keys and press
3. Use the cursor keys and select the date format (0:MMDDYY, 1:DDMMYY, or 2:YYMMDD) and
Note: The selection will affect all existing files and all files created or transferred, except captured or
downloaded from Terminal mode.
4. Press
2.4 Setting the Tabular Display Mode
The Tabular display mode is the default mode when the instrument is powered on. The data is
displayed in lines or columns, depending on the size of the characters and the number of
parameters present on the screen.
To add or delete parameter displayed on the screen:
1. From the Main Screen select
2. Highlight Display: Tabular using the down cursor key and press
3. A screen with the list of parameters is displayed. The parameters currently on the Surveyor 4a
4. Select a parameter to display using the
Note: To delete a displayed parameter, select the parameter and press Remove.
5. When all the parameters to be displayed are selected, press
Note: Some of the parameters, such as temperature, can only be displayed in one unit. For example, if Temp:
°C is added, Temp: °F cannot be displayed. If Temp: °F is added, Temp: °C will be automatically removed.
Changing the Date Format
Page 10
using the
key.
BACKSPACE
(HHMMSS). Press
DONE
briefly the "Setup Successful! Press any key..." message will be displayed.
then press
.
SELECT
when the correction selection is made.
DONE
are preceded by numbers. These number provide the order of appearance (from 1 to 24) on
the real-time display lines. The parameter without numbers are not currently displayed on the
Surveyor 4a screen.
to the real-time screen (tabular display). The new parameter(s) should be added to the screen.
RIGHT
when complete. The Surveyor 4a will make a sharp beep noise and
.
SETUP/CAL>SETUP
.
SETUP/CAL>SETUP
and
UP
DOWN
key.
DONE
and
cursor keys to enter the new time
LEFT
.
SELECT
.
SELECT
cursor keys and press
. Press
DONE
GO BACK
.
ADD
to return
Advertisement
Table of Contents
