Smart Card Reader - HP EliteBook 650 15.6 inch G9 Maintenance And Service Manual

Before removing the NFC module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the NFC module:
1. Remove any protective tape covering the module and reuse during replacement.
2. Disconnect the antenna cable from the ZIF connector on the NFC module (1).
3. Disconnect the system board cable from the ZIF connector on the NFC module (2).
4. Use a tool to release the module from the computer (3). The NFC module is secured with adhesive.
5. Remove the NFC module from the computer (4).
Reverse this procedure to install the NFC module.

Smart card reader

To remove the smart card reader from the top cover, use this procedure and illustration.
Table 6-6 Smart card reader description and part number
Description
Smart card reader
Smart card reader cable
Smart card reader bracket (available in the Bracket Kit)
Before removing the smart card reader, follow these steps:
1. Prepare the computer for disassembly (see
56 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 51).
Preparation for disassembly on page
41).
41).
Spare part number
M21398-001
N27591-001
N21997-001
41).