Paper Feed Motor Removal; Power / Parallel / Usb Board Removal - Lexmark 4098-001 Service Manual

4098-001

Paper Feed Motor Removal

1. Remove all covers.
2. Remove the sheet feeder.
3. Disconnect (J12) the paper feed motor from the system board.
4. Remove the two screws mounting the paper feed motor and
remove the motor. Note the routing of all cables.

Power / Parallel / USB Board Removal

1. Remove all covers.
2. Disconnect the system board cable.
3. Remove two screws and disconnect two ground wires.
4. Depress latches and slide the card out.
Printhead Carrier Assembly / Shaft Removal
1. Remove all covers.
2. Apply pressure to the idler pulley and remove the belt from the
transport carrier motor.
3. Remove the retainers from the ends of the carrier shaft.
4. Slide the shaft left and remove from the printer.
5. Disconnect printhead cables from the system board.
Note: The carrier is attached to the belt at a raised tab. When
reinstalling, be sure the belt tab and carrier are aligned.
6. Remove the carrier belt from the rear of the carrier.
7. Remove the carrier.
Repair Information
4-7