Advertisement
4.
Run over the entire glove
surface in this way, while
keeping the trigger pushed
to see the glove's correct
conductivity using the STATUS
LED.
To validate the DSES operation, the status LED must never turn red when
checking the different glove zones:
•
palm
•
five fingers
•
inner side
•
outside
In addition to the daily checks, it is essential to visually inspect the glove to
check its condition.
To get the best conductivity, it is also essential to hand-clean the conductor glove
every week in cold, clean water without detergent.
Check the cutting head cleanliness. Dirt can alter both the conductivity and
the correct operation of the safety system.
INFACO cannot be held liable for failures caused by gloves in poor
condition.
5.
Release the trigger, the test is complete.
DSES check and calibration
Conductivity
level
LED
Good
Insufficient
13
Advertisement
