Advertisement
1.
Check that the tab is properly fixed to the hook and loop on the
conductor glove. Check the DSES wire condition.
2.
Restart your pruning shear and check the DSES operation using the
procedure ("Checking correct operation" section on page 11).
3.
If the problem persists, take the pruning shear to your dealer so that they
can read it.
4.
Pruning shear reading indication (only by your dealer using the reading
interface): Fault D-07.
5.
If your pruning shear is operational and the DSES LED is steady red and
the D-07 fault is displayed when reading the data, this indicates a DSES
system failure.
If the DSES LED is steady red and the D-07 fault is present, the pruning
shear will be operational if it is not configured to level 3 safety, BUT
the user will no longer be protected by the system.
Reminder: use of the device is prohibited if there is safety system
malfunction.
16
The DSES LED is steady red and the user has not
momentarily or permanently disabled the system: there is
a fault.
Advertisement
