Before Shooting - JVC VideoMovie GR-A30 Instructions Manual

BEFORE SHOOTING
I
Loading a Video Cassette
1
2
3
0
rn
Open the cassette holder by pressing the EJECT
button
Insert the cassette with its printed arrow facing
outward.
First remove tape slack, then insert the
cassette correctly. See page 3.
Close the cassette holder by pushing its center
area. The tape will be automatically loaded for
recording standby.
Unloading a Video Cassette
1. Press the EJECT button.
The cassette holder will open.
2. Remove the cassette .
3 . Close the cassette holder by pushing its center
area.
Note:
•The cassette can be ejected even when the
power is off.
The holder may not open if the battery is com-
pletely discharged .
Notes:
•Loading a cassette is possible while the power is
either on or off . However, to save battery power, it
is recommended that you load a cassette while the
power is off. If you press the EJECT switch with
the power off, the power turns on for tape loading
and t hen off automatically. Later, when you ac-
tually begin shooting, you only have to slide the
POWER switch and then the start/stop button.
•Do not repeat loading and unloading of the cassette
without running the tape, as this will slacken the
tape, causing tape damage .
Adjusting the Grip Strap
1
Separate the Velcro strip to expand the loop .
2
Pass your right hand through the loop and grasp
the lens grip . Adjust the length of the strap to
suit your hand size and refasten the Velcro strip .
6